35668-4701
INSTRUCTION BOOKLET
GAS HOB
ZBG 509 SS
CONTENTS
Specifications
Page
Page
Page
Page
Page
Page
Page
Page
4
5
5
6
7
7
8
9
Installation
Electrical Connections
Use and Care
Operation
Maintenance and cleaning
Servicing
Peace of Mind for 24 Months
SPECIFICATIONS
Gas Hob Burners:
DIMENSIONS
Height (overall):
Depth:
74 mm. (see drawing)
510 mm.
860 mm.
1 Rapid Burner (Central)
1 Auxiliary Burner (Front/Left)
3 Semirapid Burners (Rear/Left - Rear/Right -
Front/Right)
Width:
Automatic Taps Ignition Switches: YES
824
18
18
74
SR
SR
SR
R
A
860
FO 2006
R = Rapid Burner
A = Auxiliary Burner
SR = Semirapid Burners
4
INSTALLATION
It is mandatory that all operations required for the
installation are carried out by a Competent Gas
Installer (CORGI registered installers normally meet
this criteria), and in accordance with existing rules
and regulations.
Please, ensure that, once the appliance is installed, it
is easily accessible for the engineer in the event of a
breakdown.
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to
remove any protective materials, which were put on
in the factory.
The relevant instructions are to be found in the
separate installation manual.
ELECTRICAL CONNECTIONS
WARNING: THIS APPLIANCE
MUST BE EARTHED.
The plug moulded on to the lead incorporates a fuse.
For replacement, use a 3 Amp BS1362 fuse. Only
ASTA/BSI approved fuses should be used. The fuse
cover/carrier must be replaced in the event of
changing a fuse.
The manufacturer declines to accept any liability
should this safety measure not be observed.
The plug must not be used if the fuse cover/carrier is
lost.
If the plug fitted to your appliance is not suitable for
the socket outlet, it must be cut off and the
apprioriate plug must be fitted.
The cut off plug should be disposed of to prevent the
hazard of electric shocks, should it be plugged into a
13 Amp socket in another part of your home.
A replacement cover/carrier must be obtained from
your local Zanussi Service Force Centre whose
address and telephone number is listed in the
directory toward the back of this instruction book, or
you can find your local service centre by looking in
your telephone directory under 'Z'.
IMPORTANT
The wires in this mains lead are coloured in
accordance with the following code:
Green and Yellow
Blue
Brown
- Earth
- Neutral
- Live
If you fit you own plug, the colours of the wires in the
mains lead of your appliance may not correspond
with the markings identifying the terminals in your
plug. Proceed as follows:
-
connect the green and yellow wire (earth wire) to
the terminal in the plug which is marked with the
letter 'E' or the earth symbol or coloured green, or
green and yellow;
-
-
connect the blue wire (neutral) to the terminal in
the plug which is marked with the letter 'N' or
coloured black;
connect the brown wire (live) to the terminal in the
plug which is marked with the letter 'L' or coloured
red.
FO 0390
5
USE AND CARE
3
1
2
4
3
5
6
7
8
9
10
3
1. Hob Top
2. Auxiliary Burner
3. Semirapid Burners
4. Rapid Burner
5. Control knob for back left burner (semirapid)
6. Control knob for front left burner (auxiliary)
7. Control knob for central burner (rapid)
8. Ignition pushbutton
9. Control knob for back right burner (semirapid)
10. Control knob for front right burner (semirapid)
6
OPERATION
HOB BURNERS
To ensure maximum burner efficiency, it is
strongly recommended that you use only
pots and pans with a bottom fitting the size
of the burner used, so that flame will not
spread beyond the bottom of the vessel. It is
also advisable, as soon as a liquid starts
boiling, to turn down the flame so that it will
barely keep the liquid simmering.
To light a burner, turn the relevant knob
anticlockwise to maximum position and then
depress the ignition pushbutton marked by a
small electric spark symbol. Then adjust the
flame as required.
IMPORTANT
Be very careful when frying food in hot oil or
fat, as the overheated splashes could easily
ignite.
IMPORTANT
If the control knobs become difficult to turn,
please contact your local Zanussi Service
Centre.
FO 0781
MAINTENANCE AND CLEANING
Before any maintenance or cleaning can be
carried out, you must DISCONNECT the
appliance from the electricity supply.
with caution, if the marks are particularly
diffucult to remove. The burner crown may
loose its matt sueface after several
cleanings but this will no way impair its
function.
Cleaning your Gas Hob
After cleaning, be sure to wipe dry with a
soft cloth.
The hob is best cleaned whilst it is still
warm, as spillage can be removed more
easily if it is left to cool.
The pan supports are dishwasher proof. If
washing them by hand, take care when
drying as the enamelling process
The pan supports and burner crowns can be
lifted off for cleaning. Use hot detergent
water and remove stubborn marks with a
mild paste cleaner. A well moistened soap
impregnated steel wool pad can be used
occasionally leaves rough edges.
7
SERVICING
If you require service or spare parts, contact your
local Zanussi Service Force Centre. Please, carry out
the following checks before contacting your local
Zanussi Service Force Centre.
Customer Care
If you have a general enquiry concerning your
Zanussi appliance or for information on our full
appliance range, please contact our customer care
department by letter or telephone as follows:
There is no spark when lighting the gas:
Customer Care Department
Zanussi Limited
Zanussi House
Hambridge Road
Newbury
• Check that the unit is plugged in and the electrical
supply is switched on
• Check that the RCCB has not tripped (if fitted)
• Check the mains fuse has not blown
Berkshire
RG14 5EP
The gas ring burns unevenly:
Tel: 01635-521313
• Check the burner cover has been replaced
correctly, e. g. after cleaning
• Check the main nozzle is not blocked and the
burner ring is clear of food particles
If after carrying out the above checks your appliance
is still faulty, contact your local Zanussi Service Force
Centre, whose address and telephone number can
be found in the accompanying customer care booklet,
and also in your local telephone directory under 'Z'.
Please, ensure you give the model and serial number
of the appliance.
In-guarantee customers should ensure that the
above checks have been made as the engineer
will make a charge if the fault is not a mechanical
or electrical breakdown. Please, note that proof of
purchase is required for any in-guarantee service
call.
8
PEACE OF MIND FOR 24 MONTHS
Zanussi Standard Guarantee Conditions
* Damage or calls resulting from transportation,
improper use or neglect, the replacement of
any light bulbs or removable parts of glass or
plastic.
This guarantee is in addition to your statutory
and other legal rights.
We, Zanussi Ltd, undertake that, if, within the 24
months of the date of the purchase, this
ZANUSSI appliance or any part thereof is
proved to be defective by any reason only of
faulty workmanship or materials, we will, at our
option, repair or replace the same FREE OF
ANY CHARGE for labour, materials or carriage
on condition that:
* Costs incurred for calls to put right machines
improperly installed or calls to machines
outside the UK and the Republic of Ireland.
* Appliances found to be in use within a
commercial or similar environment, plus
those which are the subject to rental
agreements.
* The appliance has been correctly installed
and used only on the gas and electricity
supply stated on the rating plate.
* Products of Zanussi manufacture which are
NOT marketed by Zanussi Ltd.
* The appliance has been used for normal
domestic purpose only, and in accordance
with the manufacturer's operating and
maintenance instructions.
EU Countries - The standard guarantee is
applicable but subject to owner's responsibility
and cost to ensure the appliance meets the
standards set by the country to which the
product is taken. The Zanussi Company in the
country concerned will be pleased to advise
further.
* The appliance has not been serviced,
maintained, repaired, taken apart or
tampered with by any person not authorised
by us.
Sight of your purchase receipt will be
required by them.
* The appliance is still in the possession of the
original purchaser.
All service work under this guarantee must be
undertaken by a Zanussi Service Force Centre.
Home visits are made between 8.30am and
5.30pm Monday to Friday.
Visit may be available outside these hours in
which case a premium will be charged.
Any appliance or defective part replaced shall
become our property.
EXCLUSIONS
This guarantee does not cover:
9
|