™
Cabrio Automatic Washer
PRODUCT MODEL NUMBERS
RECESSED AREA AND CLOSET INSTALLATION
WTW6700T
For closet installation, with a door, the minimum ventilation openings in the top and
bottom of the door are required (view B). Louvered doors with equivalent air ventilation
openings in the top and bottom are acceptable.
3"
(7.6 cm)
Electrical: A 120-volt, 60 Hz, AC-only,
15 or 20 amp fused electrical supply is required.
A time-delay fuse or circuit breaker and separate
circuit are recommended.
14" max.
(35.6 cm)
2
48 in.
(310 cm2)
17"
(43.2 cm)
Water: A water heater set to deliver 120°F (49°C)
water to the washer. Hot and cold faucets located
within 3 ft (90 cm) of the hot and cold water fill
valves, and water pressure of 20-100 psi
24 in2.
(155 cm2)
3"
(7.6 cm)
(138-690 kPa) for best performance.
1"
27¹⁄₂"
1"
1"
27"
5"
(2.5 cm)
(69.9 cm)
(2.5 cm)
(2.5 cm) (68.6 cm)
(12.7 cm)
A
B
C
Front view
Side view
Closet door with vents
DRAIN SYSTEM OPTIONS
Standpipe drain system - wall or floor (view A & B)
Laundry tub drain system (view C)
The laundry tub needs a minimum
20 gal. (76 L) capacity. The top of the
laundry tub must be at least 39" (99 cm)
above the floor and no higher than
96" (244 cm) from the bottom of the
washer.
Floor drain system (view D)
The standpipe drain requires a minimum diameter standpipe of
2" (5 cm). The minimum carry-away capacity can be no less
than 17 gal. (64 L) per minute.
The floor drain system requires a siphon
break that may be purchased separately.
The siphon break must be a minimum of
28" (71 cm) from the bottom of the
washer. Additional hoses might be
needed.
The top of the standpipe must be at least 39" (99 cm) high and
no higher than 96" (244 cm) from the bottom of the washer.
39"
28"
(99 cm)
39"
(71 cm)
(99 cm)
A
B
C
D
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10131461
10-22-07
|