Gas Dryer
PRODUCT MODEL NUMBERS
WGD70HEB, WGD80HEB, WGD86HEB,
WGD88HEA, WGD94HEA, WGD96HEA
Front view:
Side view:
27"
(686 mm)
381/8"
(968 mm)
3
/4"*
(18 mm)
Back view:
Recommended Installation Spacing:
61/4"
(159 mm)
3"
(76 mm)
18" min.
(457 mm)
48 in.2 min.
(310 cm2)
Water inlet
(Steam Models Only)
297/8"*
(759 mm)
53/4"*
(146 mm)
31/2"*
(89 mm)
Vent
Gas
24 in.2 min.
(155 cm2)
5"
3"
(76 mm)
(127 mm)
61/8"*
(156 mm)
3/4"*
(18 mm)
143/8"
1"
(25 mm)
1"
(25 mm)
(365 mm)
253/4"
(654 mm)
* 0" (0 mm) spacing is allowed.
NOTE: Most installations require a minimum of 5" (127 mm) clearance
behind dryer for exhaust vent with elbow. See “Venting Requirements”.
Installation spacing for recessed area or closet installation
The dimensions shown below are for the recommended spacing for this dryer.
■ Additional spacing should be considered for ease of installation and servicing.
■ Additional clearances might be required for wall, door, and floor moldings, and dryer venting.
■ Additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
■
For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are acceptable.Companion appliance spacing should also
be considered.
W10558994
01/2013
|